Table of Contents
Advertisement
Tip Wipe Height Adjustment
c. Tighten the tip wipe assembly mounting screw.
d. Manually move the head back and forth to verify that the brush and flicker are
6. Repeat
assembly (right side).
Tip
Shield
Flicker
Brush
Adjustment
Screw
contacting the tip shield without extreme resistance.
step 4
and
step 5
Make sure that the toggle bar is in the lower position when verifying/adjusting the
height of the support tip wipe assembly.
© Copyright 2020 Stratasys. All rights reserved.
above for the support head (right side) and support tip wipe
Figure 23: Tip Wipe Detail
Manual Tip Calibration
Support
Head
Model
Head
Support
Tip Wipe
Model Tip
Wipe
Page 145
Advertisement
Table of Contents
