Table of Contents
Advertisement
Working with the Queue Page
1. Network transfer via the GrabCAD Print application on your workstation PC. See
"GrabCAD Print Method" (page 47)
for adding jobs to the Job Queue.
2. USB method via a USB flash drive inserted into one of the available USB ports on the front
of the printer. See
used as a backup to the GrabCAD Print method if you are unable to transfer job files to the
printer via your Ethernet connection (due to poor connectivity, a network outage, etc.) or
Wi-Fi connection. This method also provides a convenient option for you to reprint a
common job, as you can store the processed job file on the USB flash drive and access it
repeatedly.
GrabCAD Print Method
As part of the printer's installation and setup process, you should have downloaded and
installed the GrabCAD Print application onto your workstation PC (see
Software" (page 33)
then transfer them to the printer (via your facility's Ethernet connection or via Wi-Fi) to be built.
Jobs are sent to the printer in CMB format and are placed directly into the Job Queue. No
additional steps are required to add a job to the Job Queue when sending job files directly to
the printer via GrabCAD Print. After sending the job file to the printer navigate to the Queue
page by pressing the Queue button within the Navigation Menu. The transferred job file will be
displayed within the Job Queue list. Jobs will appear within the Job Queue in the order they're
sent to the printer from GrabCAD Print. To build a specific job, that job must be listed as the
first item in the Job Queue. You can sort jobs within the Job Queue as needed to select the job
you'd like to print (see
USB Method
The printer features three USB ports. A USB flash drive can be inserted into any of these ports
and job files contained on the flash drive can be added to the Job Queue. Please note that job
files should be processed using GrabCAD Print before they are placed onto the flash drive and
subsequently added to the Job Queue. Once the flash drive is plugged into one of the printer's
USB ports, you will need to perform the following steps to add the desired job file to the Job
Queue:
3. Plug a USB flash drive into one of the available USB ports on the printer (see
Figure 3 (page 20)
4. Navigate to the Queue page by pressing the Queue button within the Navigation Menu.
for detailed instructions. This is the preferred method
"USB Method" (page 47)
for details). GrabCAD Print is the software used to process job files and
"Editing the Job Queue" (page 50)
for USB port locations).
© Copyright 2020 Stratasys. All rights reserved.
Adding a Job to the Job Queue
for detailed instructions. This method can be
for details).
"GrabCAD Print
Page 47
Advertisement
Table of Contents
