Table of Contents
Advertisement
Customer Replaceable Units
7. While holding down the retaining slot on the cover support bracket, tilt and lift the side
panels off the retaining pins (3) at the base of the oven frame. See
8. Remove the side panel from the printer.
Installing the Side Panels
1. Install the side panel to the retaining pins (3) at the base of the printer frame. See
Figure 19 (page
2. Align the mounting holes (2) in the side panel's welded channel with the holes in the printer
frame. Make sure that the tab at the bottom of the channel engages the side panel retaining
slot. See
3. Use a 3 mm hex wrench to reinstall the mounting screws (2). Torque to 21 in-lbs. See
Figure 19 (page
4. Close the top cover.
5. Install the rear panel. See
Figure 19: Side Panel Retaining Pins Detail (right side panel shown)
164).
Figure 18 (page
163).
164).
"Installing the Rear Panel" (page
© Copyright 2020 Stratasys. All rights reserved.
Right and Left Side Panels
Figure 19 (page
Side Panel
Retaining Pins
161).
164).
Page 164
Advertisement
Table of Contents
