Table of Contents
Advertisement
As Needed Maintenance
4. Using a 2.5 mm hex wrench, remove the inside door panel mounting screws (11). See
Figure 40 (page
Inside door panel
5. Pivot the inside door panel away from the door assembly. The pivot arms will prevent the
door panel from fully separating. See
6. Clean the glass surfaces with a commercial glass cleaner.
Installing the Door Panel
1. Push the top of the door panel toward the door assembly.
2. Close the door panel and make sure that the panel and frame mounting holes are aligned.
3. Using a 2.5 mm hex wrench, install the inside door panel mounting screws (11). See
Figure
4. Close the oven door.
187).
Figure 13: Inside door panel mounting screw locations
13.
Do not over-tighten the inside door panel mounting screws.
© Copyright 2020 Stratasys. All rights reserved.
Cleaning the Oven Door glass Surfaces
Pivot arm (2)
Figure
13.
Page 158
Advertisement
Table of Contents
