Table of Contents
Advertisement
Changing Printer Defaults
Changing Printer Defaults
Several factory presets can be changed via the options within the Tools page. To access this
page, press the Tools button within the Navigation Menu.
The options within the Tools page are organized into 6 categories: Settings, Calibration,
Maintenance, Network, Power, and Light. The defaults specified within the following
instructions are accessible via the Settings page. To open this page press the Settings button
within the Tools page.
After making the necessary adjustments to a default setting, press the Back button in the
upper-left corner of the page to exit and return to the main Settings page.
Job Storage
The Keep Previous Job setting determines whether or not the printer's previous job is stored
within the Job Queue once a build is complete (see
concerned about other users of your printer seeing what you've built, this setting will prevent
the printer's previous job from being accessible after the build is complete. By default this
setting is set to On, meaning that the printer's previous job file is stored within the Job Queue
making it available for re-selection upon completion of the build.
When this setting is set to Off, the printer's previous job file will be deleted from the Job Queue
upon completion of the build. The job's file will need to be resent to the printer in order to be
built again.
To configure this setting, press anywhere within the Keep Previous Job row; the Keep Previous
Job page will be displayed. Use the radio buttons within this page to turn the setting On and Off
as needed.
Figure 24: Keep Previous Job
© Copyright 2020 Stratasys. All rights reserved.
"Wait for Part" (page
72)). If you're
Job Storage
Page 120
Advertisement
Table of Contents
