Table of Contents
Advertisement
Working with the Tools Page
To configure this setting, press anywhere within the row; the Keep Previous Job page will be
displayed. Use the radio buttons within the page to turn the setting On and Off as needed; On
is selected by default.
Part Placement
The Part Placement setting gives you the ability to select a job's placement on a substrate. By
default, single part jobs are built in the center of a substrate while packs are built according to
their selected placement within GrabCAD Print. Therefore, when this setting is set to Off, single
part jobs will automatically be built in the center of the substrate and packs will be built
according their selected placement within GrabCAD Print. To configure this setting, press
anywhere within the row; the Part Placement page will be displayed. Use the radio buttons
within the page to turn the setting On and Off as needed.
When this setting is set to On, you will be able to select a job's location on the substrate prior to
starting the build (see
be displayed asking you to select the part's build location (see
contain a graphic representing your printer's platen as well as a blue bounding box graphic (the
imaginary box surrounding the part).
Figure 40: Configure Keep Previous Job
Figure 41: Part Placement
"Selecting a Job to Build" (page
© Copyright 2020 Stratasys. All rights reserved.
112)). At the start of a build a dialog will
Figure
42). The dialog will
Settings
Page 74
Advertisement
Table of Contents
