Customer Replaceable Units
1. Power OFF the printer. See
2. Using a T8 Torx wrench, remove the mounting screws (2) that secure the touchscreen to
the display housing. Retain the mounting screws. See
3. While supporting the touchscreen, tilt it away from the bracket to disconnect the grounding
cable, touch extender cable and the flat display cable from the back of the display. Retain
the nut and star washer. See
Figure 28: Touchscreen mounting screw locations
Note:
The flat display cable connector is fragile. Simultaneously pull both corners of the
connector straight out, without rocking back and forth.
© Copyright 2020 Stratasys. All rights reserved.
"Powering Off" (page
Figure 29 (page
175).
Touchscreen Display
159).
Figure 28 (page
174).
Page 174