Table of Contents
Advertisement
Customer Replaceable Units
Installing the Z Drive Belt
1. Using a small flat head screwdriver, relax the belt tension by gently prying the Z motor
tension bracket away from the compression spring. See
2. Install the Z drive belt to the Z motor pulley.
3. Install the Z drive belt to the Z axis lead screw pulley.
4. Remove the flat head screwdriver from the tension bracket to restore proper tension to the
Z belt.
5. Rotate the lead screw pulley two revolutions to align the Z drive belt on both pulleys.
6. Using a 3mm hex wrench, tighten the Z motor mounting screws (4). See
Figure 32 (page
7. Reinstall the top cover. See
8. Close the front top cover.
Y Bellows
Required Tools
•
3 mm hex wrench
Removing the Y Bellows
1. Power OFF the printer.
2. Open the front top cover.
3. Remove the front Y bellows assembly. See
a. Remove the clips (4) that secure the front bellows retainer to the front of the oven
b. Remove the clips (4) that secure the front bellows retainer to the front of the X bridge
c. Remove the front Y bellows and retainers from the gantry enclosure.
d. Retain the Y bellows retainers for re-installation.
4. Remove the back Y bellows assembly. See
a. Remove the clips (4) that secure the back bellows retainer to the rear of the oven
b. Using a 3 mm hex wrench, remove the screws (3) that secure the back bellows retainer
c. Remove the back Y bellows and retainers from the gantry enclosure.
179).
Move the X bridge as necessary to access Y bellows mounting clips and screws.
frame.
assembly tray.
frame.
to the back of the X bridge assembly tray.
© Copyright 2020 Stratasys. All rights reserved.
"Installing the Top Cover" (page
Figure 34 (page
Figure 34 (page
Figure 33 (page
179).
167).
181).
181).
Y Bellows
Page 180
Advertisement
Table of Contents
