Table of Contents
Advertisement
Loading Material
material tube. Cut the 1.2 meters of filament using the 5" cutter included in the Welcome Kit.
This length of material is removed for moisture control. Refer to
details.
The material coil box is ready to be connected to the printer. Follow the steps in
Material Coil Box To Printer" (page 98)
head.
Connecting Material Coil Box To Printer
Once you've properly prepared a material coil box, you can begin the process of loading
material. Pre-loading filament to the drive wheels places the filament into position to be loaded
to the liquefier tip within the head.
To connect and load material from a material coil box:
Figure 5: Material Coil Box Details
Filament
Memory Chip
Filament Tube
© Copyright 2020 Stratasys. All rights reserved.
Connecting Material Coil Box To Printer
to connect the material coil box and load material to the
Figure 5
for material coil box
"Connecting
Page 98
Advertisement
Table of Contents
