Table of Contents
Advertisement
Customer Replaceable Units
9. Using a 2.5 mm hex wrench, remove the sensor bracket mounting screws (2). See
Figure
10. Remove the sensor and bracket from the latch assembly and retain them for re-installation.
See
Installing the Oven Door Latch
1. Using a 2.5 mm hex wrench, install the sensor bracket mounting screws (2) to secure the
sensor mounting bracket to the oven door latch assembly. See
2. Using a 4 mm socket wrench, install the door latch assembly mounting nuts (2) to secure
the door latch assembly inside the oven door assembly. See
3. Connect the door latch assembly sensor cable connectors (2).
4. Install the inside door panel into the door assembly. See
a. Angle the inside door panel slightly and insert the pivot nuts into the lower notches on
b. Gently press down on the door panel until the pivot nuts are fully seated inside the door
c. Rotate the top of door panel toward the door assembly. Gently press in the pivot arms
42.
Figure
42.
Figure 42: Door latch sensor mounting bracket detail
both sides of the door frame.
frame.
to insert them into the upper notches on both sides of the door frame.
© Copyright 2020 Stratasys. All rights reserved.
Oven Door Latch
Figure 42 (page
Figure 41 (page
187).
Figure
43.
188).
Page 188
Advertisement
Table of Contents
