Removing Power Supplies - Oracle Fabric Interconnect Series User Manual

Removing Power Supplies

2. Grasp the fan module by the handle, and gently slide the fan module into the
chassis (1).
page 106
FIGURE 64 Inserting a Fabric Interconnect F1-4 Fan Module
When the fan module is almost all the way inserted, you might feel some resistance, which
is caused by the fan module's power socket meeting its mating part. Continue to apply gentle
pressure until the fan module is fully seated in the Fabric Interconnect F1-4 chassis. The
fan module is correctly seated when the fan module sits flush with the face of the Fabric
Interconnect F1-4.
3. When the fan module is correctly seated, use the screwdriver to tighten the
screws on the top corners of the fan module (2).
Removing Power Supplies
This section documents how to remove and install a power supply (PSU). You can replace one
PSU at a time without powering down the Fabric Interconnect. For this procedure, you will
need a #2 Phillips (cross-head) screwdriver.
Caution -
overtighten screws or they can break.
106 Oracle Fabric Interconnect Hardware User's Guide • July 2016
Figure 64, "Inserting a Fabric Interconnect F1-4 Fan Module," on
shows inserting the fan module.
When tightening screws, make sure to tighten them to lightly snug. Do not