Replace the Fabric Interconnect F1-15 QDR Fabric Board
FIGURE 74
4.
When both Fabric Board handles are in contact with the threaded standoff on the
faceplate, use the screwdriver to sink the captive screws (2), which tighten into
the threaded standoffs.
Replace the Fabric Interconnect F1-15 QDR Fabric
Board
The Fabric Interconnect F1-15 Fabric Board is on the rear of the chassis. To replace the Fabric
Interconnect F1-4 Fabric Board, you will need a #2 Phillips-head screwdriver.
Note -
Fabric Board. If you are upgrading from a non-QDR Fabric Board to a QDR Fabric Board,
use the procedure documented in
Board" on page
To replace the Fabric Interconnect F1-15 QDR Fabric Board, follow this procedure:
1.
Power down the Fabric Interconnect.
118
Oracle Fabric Interconnect Hardware User's Guide • July 2016
Securing the Fabric Interconnect F1-4's Fabric Board
This procedure is applicable to replacing a QDR Fabric Board with another QDR
128.
"Upgrading a DDR Fabric Board to a QDR Fabric