Remove Fabric Interconnect F1-15 I/O Modules - Oracle Fabric Interconnect Series User Manual

Remove Fabric Interconnect F1-15 I/O Modules

Caution -
out of its shipping package or the Fabric Interconnect chassis, make sure you place it on an ESD
safe bag or a grounded work surface such as a rubberized work mat.
Remove Fabric Interconnect F1-15 I/O Modules
With the exception of the Management module, which must be installed in slot 16 of the Fabric
Interconnect F1-15's module bay, the I/O modules can be installed in any of the remaining 15
slots. All I/O modules except the Management module can be installed or removed while the
system is running. For information about removing and installing the Management module, see
"Removing and Installing the Management Module" on page
To perform this procedure, you will need a #2 Phillips (cross-head) screwdriver.
Caution -
overtighten screws or they can break.
To remove and insert a Fabric Interconnect F1-15 I/O module, follow this procedure:
1. Before removing an I/O module, use XgOS to shutdown the I/O module.
2. Disconnect any cables attached to the module.
3. Using the screwdriver, turn the locking handle (1) located at the bottom edge of
each module 90 degrees counterclockwise. See
F1-15 I/O Module Locking Handle," on page
140 Oracle Fabric Interconnect Hardware User's Guide • July 2016
When replacing the I/O Modules: - wear an ESD wrist strap - When the hardware is
When tightening screws, make sure to tighten them to lightly snug. Do not
147.
Figure 91, "Fabric Interconnect
141.