Oracle Fabric Interconnect Series User Manual page 52

Install the Fabric Interconnect F1-4
Note -
angle brackets need to be attached to the rack. Before attaching the brackets, make sure that the
marks you made on the front and rear rack posts are level.
FIGURE 25
11. Orient the Fabric Interconnect so that the rack-depth measures are pointing
towards the opposite end of the equipment rack shown in
Right Angle Brackets to the Equipment Rack," on page
While supporting the Fabric Interconnect, hold it level and slide it into the rack
12.
(1). See
on page
sliding the Fabric Interconnect F1-4 into the correct location.
Choose either of the following workflows based on the whether you have a
13.
standard 4-post rack or a 27" Sun/Oracle rack:
"Attach the Right Angle Bracket" on page 31
■
52 Oracle Fabric Interconnect Hardware User's Guide • July 2016
If you marked the rack posts as documented in
Attaching Right Angle Brackets to the Equipment Rack
Figure 26, "Attaching the Rack Depth Measures to the Angle Brackets,"
53. You can use the marks you made in
Step 3, you should know where the right
Figure 25, "Attaching
52.
Step 3 to make sure you are