Installing A Host Channel Adapter; Install A Host Channel Adapter - Oracle Fabric Interconnect Series User Manual

Installing a Host Channel Adapter

Host Channel Adapter (HCA) cards are only required for servers that do not have InfiniBand
interfaces. Check the manufacturer's documentation to determine if your server requires an
HCA card. If you must install an HCA card, refer to your server's service label or user manual
for information.
Different servers have different methods for installing an HCA card. This section documents
one HCA installation procedure for a common server. You can use the procedure as a
general guideline for installing the HCA card, but Oracle recommends you also consult the
documentation from the server's manufacturer for specific installation information.
Note -
far as possible, before inserting the cable into the connector.
To install an HCA card, you will need the following equipment:
Various screwdrivers and/or hex-head wrenches (depending on the cable and connector
■
types)
ESD wrist strap
■
Caution -

Install a Host Channel Adapter

1. Power down the server, and un-cable as necessary to gain access to the server's
PCI slots.
2. Refer to the server's documentation to select the correct slot in which to install
the HCA card.
Remove the server's cover. See
3.
page
tabs (1), before sliding the cover off of the server (2).
When using Gore InfiniBand cables, push the connector lock towards the cable's end, as
Observe proper ESD procedures when handling HCA cards.
76. The illustration shows applying downward pressure on securing
Figure 46, "Removing the Server's Cover," on
Installing the Fabric Interconnect
Installing a Host Channel Adapter
75