Removing The Hardware; To Prepare The Hba For Hot-Plug Removal Using The Module Handle; To Prepare The Hba For Hot-Plug Removal (Solaris Os) - Oracle Sun StorageTek ATCA 4Gb FC Dual Installation Manual

Removing the Hardware

The following instructions describe the tasks required to remove the HBA. Refer to
your system installation or service manual for detailed HBA adapter removal
instructions.
The hardware removal process involves following these general steps:
1. Preparing the HBA for hot-plug removal with one of the following:
The module handle
■
The Solaris OS
■
2. Removing the AMC module hardware
▼ To Prepare the HBA for Hot-Plug Removal
Using the Module Handle
This feature is not supported at this time.
▼ To Prepare the HBA for Hot-Plug Removal
(Solaris OS)
If you want to remove the HBA without first halting the operating system and
removing power from the associated server blade, you may first prepare it for
removal as follows:
1. Use the cfgadm command to identify the HBA to be removed.
% cfgadm
Ap_Id
pcie5
pcie6
2. Use the cfgadm -c unconfigure command to unconfigure the attachment
point ID (Ap_Id) for the HBA.
Type Receptacle
fibre/hp connected
fibre/hp connected
Occupant
configured
configured
Chapter 2 Hardware Installation and Removal
Condition
ok
ok
15