Adding Your T3010/T5000 To The Rack; Lan/Wan Connections; Connecting Power To The Appliance - Oracle Talari T3010 Hardware Manual

| Oracle Talari T3010/T5000 | Hardware Guide

Adding Your T3010/T5000 to the Rack

1. Extend the outer rails as illustrated in
2. Align the inner rails attached to the chassis with the outer rails attached to the rack.
3. Slide the inner rails into the outer rails and keep the pressure even on both sides, and push
the chassis into the rack. When the chassis is pushed completely into the rack, it should click
into the locked position.
4. Optional: Use the screws included in the mounting kit to secure the front of the chassis to
the rack.

LAN/WAN Connections

When connecting each Ethernet (LAN or WAN) cable to the appropriate connector on the T3010 or
T5000:
 Position the cables carefully so that they do not put strain on the connectors.
 Organize cables in bundles so that cables do not intertwine.
 Inspect the cables to make sure that the routing and bend radii are satisfactory.
Reposition cables if necessary.
 Install cable ties in accordance with site requirements.

Connecting Power to the Appliance

When connecting power to the T3010 or T5000:
 Plug both AC power cords into the appliance.
 Plug both AC power cords into an uninterrupted AC power source.
 The appliance will start automatically.
Note: Running the T3010 or T5000 with a single power supply is not recommended for standard
operation. Connect power to both power supplies when installing these devices.
Figure 12
Figure 12: Slide APN Chassis into Rack Using Installed Rails
.