Table of Contents
Advertisement
Replacing an FP-1 Front Panel with an FP-2 Front Panel
3.
When the Front Panel is completely seated on the chassis, lower the lever arms
in a 90- degree downward arc (2) as shown in
Interconnect F1-4 Front Panel Assembly," on page
Align the captive screws in the lever arm's handle with their threaded standoffs
4.
in the front mounting bracket.
5.
Use a #2 Phillips-head screwdriver to tighten the captive screws to their
threaded standoffs (3). Do not overtighten the screws.
Replacing an FP-1 Front Panel with an FP-2 Front Panel
The FP-1 is no longer available, so if a condition r requires replacing the Front Panel, you will
receive and FP-2. This topic explains how to replace an FP-1 with an FP-2 and documents
important information about mechanical differences between the two parts.
"Installation Considerations" on page 156
■
"Power Down the Oracle Fabric Interconnect" on page 157
■
"Uncable the Oracle Fabric Interconnect" on page 157
■
"Prepare for the Procedure" on page 158
■
■
■
"Remove the Old Front Panel" on page 160
■
"Remove the Old Mounting Brackets" on page 161
■
"Install the New Mounting Brackets" on page 162
■
"Install the FP-2" on page 164
■
"Install the Oracle Fabric Interconnect" on page 165
■
"Return the Oracle Fabric Interconnect to Service" on page 166
■
Installation Considerations
Depending on when you purchased your Oracle Fabric Interconnect, your chassis contains
either an FP-1 or an FP-2:
The FP-1 has long release levers that attach to a threaded standoff near the bottom of the
■
mounting bracket's face
The FP-2 has short release levers that attach to a threaded standoff near the top of the
■
mounting bracket's face.
156
Oracle Fabric Interconnect Hardware User's Guide • July 2016
Figure 99, "Installing the Fabric
155.
Advertisement
Table of Contents
Need help?
Do you have a question about the Fabric Interconnect Series and is the answer not in the manual?
Questions and answers