Connecting Power To The Appliance; Important Note About Cabling And Bypass Mode - Oracle Talari T5200 Hardware Manual

Oracle Talari T5200 | Hardware Guide

Connecting Power to the Appliance

When connecting power to the T5200:
 Plug both AC power cords into the appliance.
 Plug both AC power cords into an uninterrupted AC power source.
 The appliance will start automatically.
Note : Running the T5200 with a single power supply is not recommended for standard
operation. Connect power to both power supplies when installing this device.
The appliance power connectors are shown below. The T5200 uses 120/240 VAC.

Important Note about Cabling and Bypass Mode

When your Oracle Talari Appliance is operating in bypass mode (e.g., when it is powered off), the
appliance acts like a crossover cable. This may cause a loss of the link between the appliance and
older network devices that do not support Auto MDI-X when straight-through cables are used to
connect the LAN and WAN ports of the appliance. In such a case, a crossover cable is required
from the Oracle Talari Appliance's WAN port to the older network device.
If your network devices support Auto MDI-X capability, the link should be automatically
established when the device enters bypass mode and there should be no need for crossover
cables. Talari recommends testing and verifying this capability with the appliance powered off.
For assistance, please contact the Talari Support team.
Figure 14: Connect Power Cables to Appliance
1 7