Attach The Right Angle Bracket - Oracle Fabric Interconnect Series User Manual

19. Continue to slide the Fabric Interconnect into the rack until the mounting
brackets contact the vertical rack post. The chassis is completely inserted into
the rack when the mounting brackets lie flush against the vertical rack post.
20. When the chassis can no longer slide into the rack, insert the pan-head screws
through the mounting brackets on the fan-unit side of the chassis, and tighten
them to secure the chassis to the rack posts. In this example, the rear mounting
brackets will secure the chassis to the rear rack posts.
21. Choose either of the following workflows based on whether you have a standard
4-post rack or a 27" Sun/Oracle rack:
"Attach the Right Angle Bracket" on page 31
■
"Attach the Right Angle Bracket in a 27" Sun/Oracle Rack" on page 35
■

Attach the Right Angle Bracket

Align the angle bracket with the screw holes on the outside of the side panels.
1.
Make sure the screw holes in the angle brackets lie flush against the slotted
edge of the side panels. The slotted edge of the angle bracket will attach to the
rack post.
2. From inside the side panels, insert the 10-32 flat-head screws through the slots
in the side panel and into the angle bracket's screw holes. Each angle bracket
requires 3 screws.
page 32 shows aligning the angle brackets and inserting the screws. When
the angle brackets are correctly installed, the slotted surface will lie flush
against the rack posts.
Figure 11, "Attaching Angle Brackets to Side Panels," on
Attach the Right Angle Bracket
Installing the Fabric Interconnect 31