Oracle Fabric Interconnect Series User Manual page 87

Fabric Interconnect F1-15 Management Module for Connection to Management
FIGURE 55
Console
There are two ways to connect to the serial port on the Fabric Interconnect Management
module:
Connect directly to the Serial 1 port on the Management module. This
■
step requires an adaptor that supports straight-through CAT-5 cable (or
the equivalent). See
Port" on page
Connect a remote system to the Serial 1 port using a serial console terminal
■
concentrator (for example, Cyclades).
2. Verify that the serial port on your system is set up as follows:
115200 baud
■
8 bits, no parity
■
■ VT100 encoding
1 stop bit
■
The Serial 2 port is used for debug purposes only.
Note -
Connect to a Fabric Interconnect F1-4's Management Module
The procedure in this section documents using a serial connection to the Fabric Interconnect's
management port. However, a default address is set for the Management port (192.168.1.1), so
you can also use an Ethernet connection for initial configuration of the Fabric Interconnect.
To connect to the Management Module on a Fabric Interconnect F1-4:
Connect a laptop or a remote console to the Serial 1 port on the Management
1.
module. (This connection is required for the initial system configuration.) See
Connect to a Fabric Interconnect F1-4's Management Module
"Connecting the Management Port to a DB9 Serial
86.
Installing the Fabric Interconnect 87