Installing a New G700 with an S8300
Administering an S8300 primary controller
!
CAUTION:
This administration applies only to the primary controller. If the S8300 you
CAUTION:
installed is configured as an LSP, do not perform this administration on it.
Translations are automatically copied to the LSP from the S8300 primary
controller.
Skip this section and go to
the primary controller is an S8500 or S8700/S8710.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer's network.
For the majority of administration required, see ''Administrator's Guide to Avaya Communication
Manager, 555-233-506,'' or ''Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.''
In this section, you will use the SAT interface to:
Assigning Node Names and IP Addresses for the LSPs
Administering Network Regions
Associating LSPs with Network Regions
Administering IP Interfaces
Administering the LSP Form
!
CAUTION:
Before continuing, be sure you have saved translations in Communication
CAUTION:
Manager.
Begin by resetting the system.
To reset the System
1. Telnet to the S8300, log in, and open a SAT session (type sat or dsat).
2. At the SAT prompt, type reset system 4
The system reboots.
3. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specifiied on the Node Names
screen.
170 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Administering an S8500 or S8700 primary controller
on page 175 if