Upgrading G450 Firmware From The Primary Controller; Upgrading G450 Firmware Using Gateway Installation Wizard (Giw) - Avaya G450 Install Book

Upgrading the G450 firmware

Upgrading G450 firmware from the primary controller

For a G450 without an S8300 or for a G450 with an S8300 installed as an LSP, you can upgrade
G450 firmware from the remotely located primary controller. The primary controller may be an
S8300, S85XX, S87XX, or S88XX server. See the guide for the primary controller for
information about upgrading firmware from the primary controller. See Upgrading, Migrating,
and Converting Avaya Servers and Gateways, 03-300412.
Note:
You can only upgrade using FTP on the S85XX, S87XX, and S88XX servers.
Note:
Upgrading G450 firmware using Gateway Installation
Wizard (GIW)
1. Prepare installation worksheets. See
2. Download GIW from the Avaya Support website (support.avaya.com/avayagiw) to the
laptop computer. The laptop should be running Windows 2000, Windows 2003 server, or
Windows XP to support GIW.
3. Set up a TFTP server on the G450 network. See
The GIW runs the CLI commands on the G450 so the G450 can obtain the files from the
TFTP server.
4. Download the G450 firmware files to the TFTP server. See
files to a local TFTP server
5. Run GIW to perform the upgrade. For instructions on performing the upgrade, see
Appendix D: Running the Gateway Installation Wizard (GIW)
Note:
This upgrade must be done locally.
Note:
Note:
You can only use GIW to upgrade firmware on a G450 that does not contain an
Note:
S8300.
98 Installation and Upgrades for the Avaya G450 Media Gateway
Preparing installation worksheets
on page 103.
Setting up a TFTP server
Downloading G450 firmware
on page 127.
on page 101.
on page 103.