Administer Communication Manager; The Primary Controller Is An S8300; Assign Node Names And Ip Addresses For The Lsps - Avaya G700 Installation And Upgrades

Administer Communication Manager

Perform one of the following two administration procedures in this section:
•
The Primary Controller is an
•
The Primary Controller is an S8500 or S8700 (the S8300 Is an LSP)

The Primary Controller is an S8300

CAUTION:
This administration applies only to an S8300 that serves as the primary controller for the
target G700. The S8300 primary controller can be in the target G700 or in another,
possibly remote, G700. If the S8300 is an LSP, do not administer Communication
Manager on it. Translations are automatically copied to the LSP from the S8300 primary
controller.
If the primary controller is an S8500 or S8700, skip this section and go to
S8500 or S8700 (the S8300 Is an LSP)
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer's network. For the majority of
administration required, see ''Administrator's Guide to Avaya Communication Manager, 555-233-506,''
or ''Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.''
In this section, you will use the SAT interface to:
•
Assign Node Names for LSPs
•
Define the IP Network Region
•
Add a Media Gateway.
CAUTION:
Before continuing, be sure you have saved translations in Communication Manager.
Reset the System
1
Telnet to the S8300, log in, and open a SAT session (type
2
At the SAT prompt, type
The system reboots.
3
After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assign Node Names and IP Addresses for the
LSPs
If the S8300 network configuration includes LSPs, they must be specifiied on the Node Names form.
Assign node names
1
At the S8300 SAT prompt, type
Installation and Upgrades for G700 and S8300
December 2003
S8300, or
on page 155
reset system 4
change node-names ip
Installing a New G700 with an S8300
Administer Communication Manager
The Primary Controller is an
or ).
sat dsat
to open the Node Names screen.
3
151