Setting Button And Indicator Status On The Cross-Point Control Block/Aux Bus Control Block; Configuring The Cross-Point Pad - Sony XVS-9000 User Manual

Setting Button and Indicator Status
on the Cross-Point Control Block/
AUX Bus Control Block
Setting the color of cross-point buttons
This sets the color of the 3rd row/4th row cross-point
buttons.
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
In the <Xpt Button Color> group, select one of the
following.
Source Color: Lit using the color set in the
Engineering Setup >Panel >Xpt Assign >Src
Name/Src Color menu (7322.6).
White: Lit white.
Setting cross-point indicators
You can disable the cross-point indicators so that they do
not turn on.
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
Press [Xpt Indicator], turning it off.
To enable the cross-point indicators so that they do
turn on, press [Xpt Indicator] again, turning it on.

Configuring the Cross-Point Pad

Assigning a function to a cross-point pad
button
1
In the <Xpt Pad> group of the Engineering Setup
>Panel >Operation >Xpt Module Operation menu
(7326.12), press [Xpt Pad Btn Assign].
The Xpt Pad Btn Assign menu (7326.14) appears.
The left side of the status area shows the cross-point
pad buttons. The upper right side shows the currently
selected page number and name, and the lower right
side shows a list of assignable functions.
2
In the <Bank Select> group, select the target bank to
set.
3
Select the target page to set.
No. Parameter Adjustment
1 Page
4
Press the target button to make an assignment.
5
In the list on the right, select the function to assign.
Set the numerical value of the "?" part of the function
name using the following parameters.
No. Parameter Adjustment
3 Row
a)
4 Key
Aux
DME
Util/Sbox
Macro
Mode
Level
Button
a) The parameters will vary depending on the selected function name.
6
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return button assignments to the defaults
Press [Default Recall], check the message, then press
[Yes].
The button assignments on all pages (1 to 14), including
the Jump Page Assign menu (7326.17) settings, are
returned to the defaults.
To rename a page
1
Select the target page number to set, and press [Page
Name].
2
Enter a name of up to 12 characters in the keyboard
window, and press [Enter].
Note
Lower case characters may be entered, but the entered
characters are displayed as upper case characters on
the buttons in the cross-point pad.
425
Page selection
Button row selection
Key selection
AUX bus selection
DME channel selection
Utility/shotbox bank selection
Macro register selection
Display mode selection
Level selection button selection