Metal Settings; Dim And Fade Settings; Glow Settings - Sony XVS-9000 User Manual

Video: Select the input video signal.
To use the Nega effect with [Sketch], [Edge Color],
or [Draw]
To invert white and black in the extracted video, or to
invert the outlines and the sections other than the
outlines, press [Nega], turning it on.
To mask the Sketch effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 243).

Metal Settings

Applying the Metal effect
1
Open the DME >Enhanced Video Modify >Metal
menu (4172).
2
Press [Metal], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Mix Ratio Mix level for Metal effect video and
input video
2 Y Clip Clip level of input signal luminance
level
3 Y Gain Gain level for clip-adjusted input
signal luminance level
4 Y Offset Offset added to clip and gain-
adjusted input luminance signal
4
In the <Metal Mode> group, select the type of metallic
gloss.
Gold: Give a gold gloss to the input video.
Silver: Give a silver gloss to the input video.
Rainbow: Give a rainbow color gloss to the input
video.
Variable: Give a metallic gloss to the input video in
any color. You can set the following parameters.
No. Parameter Adjustment
2 Saturation Saturation
3 Hue Hue
To mask the Metal effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 243).

Dim and Fade Settings

Applying the Dim effect
1
Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2
Press [Dim], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Start
2 Gain
4
Press [Flat Color] and set the parameters for the color
of the rear of the picture.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation
3 Hue
Applying the Fade effect
1
Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2
Press [Fade], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 Start
2 Gain

Glow Settings

Applying the Glow effect
1
Open the DME >Enhanced Video Modify >Glow
menu (4174).
2
Press [Glow], turning it on.
242
Point where dimming starts (dim
start point)
Degree of dimming
Saturation
Hue
Point where fading starts (fade
start point)
Degree of fading