Sony XVS-9000 User Manual page 176

Note
With a pair file recalled, it is possible to disable pair mode
and carry out single file operations, but if you then re-
enable pair mode, the output of frame memory may
become black. If this occurs, recall the pair file again.
Playing a clip (menu)
1
In the Frame Memory >Clip/Still >Recall menu
(2111), recall the file to play on the target FM output.
2
Open the Frame Memory >Clip/Still >Play menu
(2112).
The following information is displayed in the status
area in the center of the screen.
Start of clip
Duration
Playback stop point
(yellow bar)
Current position
(red bar)
Playback start point
(light-blue bar)
Note
If a playback operation is performed immediately after
a clip is created, the icon display thumbnail may not be
displayed (black display). Some time may be required,
depending on the clip file, before the thumbnail is
displayed.
3
Press [Play].
Playback starts. To stop playback, press [Stop].
To repeat playback (looping)
In the <Loop Type> group, select one of the following.
Loop: When the playback stop point is reached, playback
continues from the playback start point, and then
repeats.
Ping-Pong: When the playback stop point is reached,
playback continues in the reverse direction until the
playback start point, and then repeats.
To play audio data
Press [Audio], turning it on.
End of clip
Icon display
Start point, current
position, and stop point
thumbnails and
timecodes
For details about audio data, see "Frame memory audio
data" (page 169).
To change the playback speed
Press [Variable Speed], turning it on, and set the following
parameter.
No. Parameter Adjustment
3 Speed
To cue up
Press [Cue].
To move to the start of a clip
Press [Rewind].
To move to the end of a clip
Press [FF].
To set the playback start point
To set the current position as the playback start point, press
[Set] in the <Start TC> group.
To set a different position, press the [Start] icon display in
the status area, and enter a timecode value in the numeric
keypad window.
Pressing [Clear] in the <Start TC> group clears the set
playback start point.
To set the playback stop point
To set the current position as the playback stop point, press
[Set] in the <Stop TC> group.
To set a different position, press the [Stop] icon display in
the status area, and enter a timecode value in the numeric
keypad window.
Pressing [Clear] in the <Stop TC> group clears the set
playback stop point.
To change the current position
Press the [Current] icon display in the status area, and enter
a timecode value in the numeric keypad window.
To delete regions outside the playback range
(trimming)
You can delete the region before the set playback start
point and the region after the set playback stop point.
Press [Trim], check the message, then press [Yes].
Note
Trimming cannot be performed while clip file playback is
in progress or when recalled on a locked FM output.
Playing a clip (device control block)
You can play a clip recalled on an FM output, from the
menu, using the device control block (trackball).
For details about the buttons in the device control block
(trackball), see "Device Control Block (Trackball)"
176
Playback speed