Sony XVS-9000 User Manual page 327

M/E1 to M/E5, P/P, USER1 to USER8,
DME1 to DME4, RTR, ALL
For details about region selection, see "Region
selection in the numeric keypad control block"
(page 302).
For details about saving a master snapshot, see
"Creating and saving a master snapshot" (page 328).
The display shows the selected region name and the
last recalled register number.
4
Press the [STORE] button, turning it on.
5
Use the numeric keypad to enter the number of the
register in which you want to save.
The display shows the selected register number.
For details about selecting a register, see "Register
selection in the numeric keypad control block"
(page 302).
Note
If you press a button in which a snapshot is already
saved, the existing contents of the register will be
overwritten.
6
To add attributes (see page 325), press the following
buttons, turning them on.
Attribute
Effect dissolve
Auto transition
Note
In the numeric keypad control block, it is not possible
to add the cross-point hold attribute. When adding
attributes, use the menu (see page 331).
7
Press the [ENTER] button.
This saves the snapshot in the specified register.
The [RCALL] button and the [STORE STATS] button
light amber.
To cancel a snapshot save operation
While the [STORE STATS] button is lit amber, press and
hold the [STORE STATS] button and press the [UNDO]
button.
Recalling a snapshot
1
In the numeric keypad control block, press the
[SNAPSHOT] button.
Button
[EFF DISS] button
[AUTO TRANS] button
The control block switches to snapshot operation
mode, and the [SNAPSHOT] button and [RCALL]
button light amber.
2
Use the region selection buttons to select the target
region of the operation.
You can select more than one button.
The following region selection buttons can be operated
for snapshots.
M/E1 to M/E5, P/P, USER1 to USER8,
DME1 to DME4, RTR, ALL, MASTR
For details about region selection, see "Region
selection in the numeric keypad control block"
(page 302).
3
Use the numeric keypad buttons to enter the register
number to be recalled.
The display shows the selected register number.
For details about selecting a register, see "Register
selection in the numeric keypad control block"
(page 302).
4
To add temporary attributes (see page 325), press the
following buttons, turning them on.
Control Temporary
block attribute
Cross- A/B bus cross-
point point hold
control
block
Key cross-point
hold
Key disable
Numeric Effect dissolve
keypad
Auto transition
control
block
a) When the operation mode is set to [Xpt Hold] in the Setup menu.
b) When the operation mode is set to [Key Disable] or [Key Dsbl with
Status] in the Setup menu.
For details about operation modes, see "Setting the
operation mode of a cross-point hold button on the key
bus" (page 457).
Notes
• The cross-point hold and key disable settings are
maintained until you next press and release the
cross-point hold button.
• Adding a temporary attribute does not affect the
attribute settings saved in registers.
327
Button
[XPTHLD A] and
[XPTHLD B] buttons of
the cross-point pad
[XPTHLD KEY1] to
[XPTHLD KEY8] buttons
a)
of the cross-point pad
[XPTHLD KEY1] to
[XPTHLD KEY8] buttons
b)
of the cross-point pad
[EFF DISS] button
[AUTO TRANS] button