Sony XVS-9000 User Manual page 79

Cross-point control block button numbers
1, 2, 3, 4, ...
36, 37, 38, 39, ...
On the M/E and PGM/PST banks, each cross-point button
has two button numbers, and you use the [SHIFT] button
to switch between these numbers.
In the case of a 36-button layout, the button numbers are as
follows.
Button Number when the
shift button is not
pressed (unshifted
state)
From left side to 1 to 35
35th
The rightmost (36th) button is used as the [SHIFT] button.
When selecting the signals of button numbers 1 to 35,
press the corresponding cross-point button number. When
selecting the signals of button numbers 36 to 70, press the
[SHIFT] button and the corresponding cross-point button
number.
Notes
• The [SHIFT] button functions in the mode (hold/lock)
set in the Setup menu.
You can also disable the [SHIFT] button function.
For details, see "Setting the [SHIFT] button operation
mode" (page 406).
• The [SHIFT ALL] button assigned to the cross-point pad
is enabled, even if the [SHIFT] button use is not set. In
this case, the button numbers are 1 to 36 in the unshifted
state, and 37 to 72 in the shifted state.
• You can use the rightmost button (36th) as a [SIDE
FLAG] button. In this case, the [SHIFT] button moves
one position to the left to number 35, and the button
numbers are offset by one.
For details about the [SIDE FLAG] button, see
"Assigning the [SIDE FLAG] Button" (page 408).
(first numbers)
(second numbers)
Button numbers in the AUX bus control
block (AUX bus operation mode)
The 1st row and 2nd row are used as bus selection
delegation button rows, and the 3rd row and 4th row are
used as signal selection cross-point button rows.
The button numbers vary depending on the state of the
Number when the
[2ND DELG] button (lit/unlit) in the cross-point pad.
shift button is
pressed (shifted
When the [2ND DELG] button is lit (second
state)
delegation mode)
36 to 70
The bus selected by the delegation buttons in the 1st row is
assigned to the 3rd row, and the bus selected by the
delegation buttons in the 2nd row is assigned to the 4th
row.
In the case of a 36-button layout, the button numbers are as
follows.
Button
From left side to
35th
The rightmost (36th) button is used as the [SHIFT] button.
When selecting the bus/signals of button numbers 1 to 35,
press the corresponding cross-point button number. When
selecting the bus/signals of button numbers 36 to 70, press
the [SHIFT] button and the corresponding cross-point
button number.
Note
The [SHIFT] button functions in the mode (hold/lock) set
in the Setup menu.
You can also disable the [SHIFT] button function for the
3rd row/4th row cross-point buttons.
79
SHIFT button
..., 33, 34, 35
..., 68, 69, 70
SHIFT button
Number when the Number when the
shift button is not shift button is
pressed (unshifted pressed (shifted
state) state)
1 to 35 36 to 70