Wipe Snapshots; Wipe Snapshot Operations (Flexi Pad Control Block) - Sony XVS-9000 User Manual

Wipe Snapshots

You can save a snapshot of a wipe pattern together with all
modifiers and pattern limit settings in a dedicated register
for recall when required. There are ten wipe snapshot
registers on each switcher bank.
Use the Flexi Pad control block in each switcher bank or
the menu to save and recall wipe snapshots.
Wipe Snapshot Operations (Flexi
Pad Control Block)
Pressing the [WIPE] button in the Flexi Pad control block
switches the memory recall section to wipe snapshot
operation mode for saving, recalling, and deleting wipe
snapshots.
This section describes operation of wipe snapshots on M/
E-1 bank as an example.
WIPE button
Wipe pattern number
Memory recall section
Flexi Pad control block
Button display in the memory recall section
You press buttons in the memory recall section to select
registers (1 to 10).
The wipe pattern image is displayed on buttons for
registers with a registered snapshot. You can also rename
the register in the Setup menu (see page 422).
The wipe pattern number is displayed on the top right
button in the memory recall section.
The button color varies as follows, according to the
register state.
Gray characters on black: Register not containing a
White icon/characters on dark blue: Register containing
Lit orange: Last recalled register
When both the main pattern and sub pattern are selected
for a pattern mix, the main pattern image is displayed.
Selecting a wipe pattern
1
2
3
UNDO button
DEL button
Saving a wipe snapshot
1
2
Recalling a wipe snapshot
1
150
saved snapshot
a saved snapshot
Note
In the M/E-1 bank Flexi Pad control block, press the
[WIPE] button.
This switches the memory recall section to wipe
snapshot operation mode.
Press the [PTN NO.] button in the memory recall
section.
Use the numeric keypad to enter the pattern number
consisting of up to three digits, and press the [ENTER]
button.
The entry is applied, and the memory recall section
switches back to wipe snapshot operation mode. The
selected wipe pattern number is displayed on the top
right button in the memory recall section.
Configure the wipe you want to save.
In the Flexi Pad control block, press and hold the
[KEY] button, and press the button for the register you
want to save.
The selected button is lit orange, and the set wipe
pattern image is displayed. The set wipe pattern
number is displayed on the top right button in the
memory recall section.
Note
If you press a button in which a wipe snapshot is
already saved, the existing contents of the register will
be overwritten.
In the Flexi Pad control block, press the [WIPE]
button.