Utility Execution (Utility/Shotbox Control Block); Utility Execution (Cross-Point Control Block) - Sony XVS-9000 User Manual

Utility Execution (Utility/Shotbox
Control Block)
Mode selection buttons
Memory recall buttons
Utility/shotbox control block
In the utility/shotbox control block, you can assign actions
to 24 memory recall buttons on each of banks 1 to 20.
The bank is switched using the mode selection buttons.
The [BANK1] to [BANK6] bank 1 to 6 mode selection
buttons are assigned by default.
Action and button assignments are made in the Setup
menu.
For details about action assignment, see "Assigning a
Function to a Memory Recall Button in the Utility/Shotbox
Control Block" (page 415).
For details about mode selection button assignment, see
"Setting Utility/Shotbox Control Block Button
Assignments" (page 403).
To execute an assigned action
1
Select the target bank using the mode selection
buttons.
The selected button is lit amber, and the control block
switches to function recall mode.
The functions for the selected bank are assigned to the
memory recall buttons, and the function numbers "n-
1" to "n-24" (where n is the bank number) are
displayed. The function name is displayed if a name
has been specified for the function in the Setup menu.
2
Press the memory recall button with the registered
action you want to execute.
• For actions that enable/disable a function, the
selected button is lit orange, and the function is
enabled. To disable the function, press the button
again.
• For other actions, the function for the selected button
is executed.
Utility Execution (Cross-Point
Control Block)
1st row
Cross-point control block
You can assign actions to the cross-point buttons on the
cross-point control block, and then select them in utility/
shotbox mode. You can set assignments for each button on
utility/shotbox banks 1 to 10. The settings are common to
the M/E and PGM/PST banks.
To switch to utility/shotbox mode, use the bank 1 to 10
delegation buttons [UTL/SB 1] to [UTL/SB10] in the
cross-point pad.
Action and button assignments are made in the Setup
menu.
For details about action assignment, see "Assigning
Functions to Cross-Point Buttons of the Cross-Point
Control Block" (page 418).
For details about delegation button assignment, see
"Assigning a function to a cross-point pad button"
(page 425).
Note
You can assign the bank 1 to 10 delegation buttons for
utility/shotbox operation to the 1st row of the cross-point
control block in key/AUX bus delegation mode in the
Setup menu (see page 424).
336
Cross-point pad