Sony XVS-9000 User Manual page 12

Exporting Source Names and Destination
Names ..............................................408
Assigning the [SIDE FLAG] Button .........408
Setting the Cross-Point Delay ...................409
AUX Bus Control Block Settings ........... 410
Setting the AUX Bus Operation Mode .....410
Setting the Router Operation Mode ..........410
Settings Relating to Button
Assignment....................................... 412
Assigning Functions to User Preference
Buttons .............................................412
Assigning a Function to a Memory Recall
Button in the Utility/Shotbox Control
Block ................................................415
Assigning Functions to Cross-Point Buttons of
the Cross-Point Control Block .........418
Settings Relating to Device
Connections...................................... 419
Setting the Control Mode for P-Bus
Devices.............................................419
Assigning the Target Port to a Channel
Selection Button...............................419
Setting the AUX Bus Override Operation
Mode ................................................420
Settings Relating to Operation .............. 420
Setting the On-Air Tally............................420
Setting the Transition Rate Display
Mode ................................................420
Setting the Main Fader Lever....................420
Configuring Settings Relating to
Effects ..............................................421
Setting Source Names and Destination
Names ..............................................421
Setting Flexi Pad Control Block Button
Display and Operation .....................422
Setting the Button and Fader Lever Operation
Mode ................................................422
Setting the Operation Mode of the [ALL]
Button in the Transition Control
Block................................................423
Setting Device Control Block Button and
Trackball Operation .........................423
Setting the Macro Execution Mode...........423
Setting the Operation Mode of the Cross-Point
Control Block Button Rows.............424
Setting Button and Indicator Status on the
Cross-Point Control Block/AUX Bus
Control Block...................................425
Configuring the Cross-Point Pad...............425
Copying Cross-Point Pad Settings ............427
Setting the Display Mode of the Cross-Point
Control Block/AUX Bus Control
Block ................................................427
Setting Utility Bus Mode...........................428
Settings Relating to Control Panel
Management ..................................... 428
Setting the Screen Saver............................428
Setting Panel Sleep Mode..........................428
Adjusting the Brightness ...........................428
Setting the State of Buttons that are Not
Lit.....................................................429
Setting Beep Sound for Touch
Operation..........................................429
Calibrating the Touch Panel ......................429
Setting the Menu to Display at Startup .....429
Inhibiting Operation in the Sub Menu
Site ...................................................429
Setting the Mouse Wheel Function when
Setting Parameters ...........................429
Setting the Mouse Button Function when
Setting Parameters ...........................429
Chapter 19 Switcher Setup
Settings Relating to Switcher
Configuration.................................... 430
Adjusting the Reference Phase..................430
Specifying the Video Switching Timing ...430
Setting the Operation Mode ......................430
Setting User Regions .................................432
Assigning PGM/PST Logically to an
M/E ..................................................432
Setting DME Channel Assignments..........432
Setting the Side Flag Material and
Operation..........................................432
Setting the Sub Key Mode.........................433
Setting the Keys and DME Channels used in a
CG Border........................................433
Enabling Keyer Free Re-Entry ..................433
12