Setting And Canceling A Macro Attachment - Sony XVS-9000 User Manual

Setting and Canceling a Macro
Attachment
Setting the register to assign in a macro
attachment
You can select a macro register (1 to 250) to assign to a
control panel button or a fader lever.
Notes
• When a macro register is recalled, for example on the
numeric keypad control block or Flexi Pad control
block, the macro attachment register setting is also
changed in conjunction.
• The name of the macro attachment register is displayed
on the macro register display button while the [PRE
MACRO] button or [POST MACRO] button is pressed
on the cross-point pad of the cross-point control block.
1
Open the Macro >Register >Attach menu (5411).
2
In the list on the left of the status area, select the macro
attachment register.
3
Press [Set].
The selected register name appears on the right side of
the status area.
Setting a macro attachment to a button
This section describes setting a macro attachment to a 3rd
row cross-point button in the cross-point control block as
an example.
3rd row
Cross-point control block
PRE MACRO button
POST MACRO button
MACRO ATTACH ENABLE button
1
Select the macro attachment register.
For details about the method of operation, see
"Setting the register to assign in a macro attachment"
(page 361).
2
To set to pre macro mode, press and hold the [PRE
MACRO] button in the cross-point pad and press a 3rd
row cross-point button. To set to post macro mode, use
the [POST MACRO] button instead.
The selected cross-point button blinks amber, and the
register set in step 1 is assigned to the button.
If you make both pre macro and post macro
settings for the same button
The latter setting is enabled.
To disable a button function when a macro
attachment is set
When a macro attachment is assigned to a button, you can
configure it so that the button function is not executed.
For details, see "Setting the Macro Execution Mode"
(page 423).
To set a macro attachment in macro only mode
1
Select the macro attachment register.
For details about the method of operation, see
"Setting the register to assign in a macro attachment"
(page 361).
2
Press and hold the [PRE MACRO] and [POST
MACRO] buttons at the same time in the cross-point
pad and press a 3rd row cross-point button.
The selected cross-point button blinks green, and the
register set in step 1 is assigned to the button.
To check macro attachment settings
Press and hold the [PRE MACRO] button or [POST
MACRO] button. While the button is pressed, the buttons
for which a macro attachment is set blink as follows.
While the [PRE MACRO] button is pressed:
• Buttons set in pre macro mode: Blink amber
• Buttons set in macro only mode: Blink green
While the [POST MACRO] button is pressed:
• Buttons set in post macro mode: Blink amber
• Buttons set in macro only mode: Blink green
Setting a macro attachment to a fader lever
You can set a macro attachment to any particular position
of a fader lever in the transition control block.
361