Transition Type; Basic Operation For Transitions - Sony XVS-9000 User Manual

Transition Type

Type Description
Mix The new video progressively
fades in over the current
video. The sum of the two
video outputs is maintained
at a constant, with the output
of each at 50% at the mid-
point of the transition (i.e.,
when the fader lever is in the
center position).
NAM (non- The current video and new
additive video signals are compared,
mix) and the signal with the
higher luminance level is
given priority in the output.
The signals are compared at
the mid-point of the
transition when both signals
are at 100%, at which point
the signal with the higher
luminance level is output.
Super mix The current video is
maintained at 100% output
for the first half of the
transition as the new video
is mixed while increasing
progressively to 100% at the
mid point of the transition.
Preset A color matte (unpatterned
color mix display) is inserted during
the transition where the
current video is switched to
the new video in a two-stage
transition.
Wipe A wipe switches from the
current video to the new
video using a predetermined
pattern.
DME wipe The current video switches
to the new video, similar to a
wipe, using a DME effect.
Clip Plays back a frame memory
transition clip (movie) linked to a mix
or wipe transition.
Cut The new video
instantaneously replaces the
current video.
Basic Operation for
Transitions
Independent
key transitions
Selectable
Transition operations are performed using the transition
control block. Only background transitions can be
executed on the simple-type transition control block.
Operations on the transition control block
Not selectable
Next transition selection buttons
Not selectable
Not selectable
Transition type selection buttons
Selectable
1
Select the background video using the background A
bus cross-point buttons in the cross-point control
Selectable
block.
2
Select the part of the image to change in a transition
Not selectable
using the next transition selection buttons in the
transition control block.
Selectable
To change the background: Press the [BKGD]
To insert or remove a key: Press the [KEY1] to
To enable the key overlay order (priority) setting
To remove all the currently inserted keys: Press the
To change preset keys and backgrounds
83
Transition execution section
Transition control block
button, turning it on.
[KEY8] buttons, turning them on.
after the transition: Press the [KEY PRIOR]
button, turning it on.
[BKGD] button twice in rapid succession
(available only when double-press operations are
enabled in the Setup menu).
simultaneously: Press the [ALL] button.