Assigning Output Signals; Adjusting Video Clips - Sony XVS-9000 User Manual

Assigning Output Signals

1
In the Engineering Setup >Switcher >Output menu
(7333), press [Output Assign].
The Output Assign menu (7333.1) appears.
The status area shows a list of output signal numbers
and source names of assigned signals on the left.
2
In the <Output Assign> group, set the signals to
display in the list on the right.
Re-Entry Source: Display re-entry signals (multiple
assignment is supported)
M/E-1 Out1 to Out6
M/E-2 Out1 to Out6
M/E-3 Out1 to Out6
M/E-4 Out1 to Out6
M/E-5 Out1 to Out6
1)
P/P Out1 to Out6
M/E-1 to M/E-5 Proc Video
P/P Proc Video
M/E-1 to M/E-5 Proc Key
P/P Proc Key
DME Monitor Video
DME Monitor Key
Color Bkgd 2
Frame Memory 1 to 20
Multi Viewer 1 to 4
Undefined
Aux Bus: Display AUX, preset, edit preview output
(duplicate assignment is not supported)
Preset
Edit Preview
Aux1 to 48
1) Signals are configured using the Engineering Setup >Switcher
>Config >M/E Output Assign menu (7331.1).
2) Only XVS-9000 multi viewer output connectors (81 to 96) are
configurable.
3
Select the output connector number and signal to
assign.
For signals not assigned, select "Undefined" in the
signal list or press [Inhibit] to set to "Undefined."
4
Press [Set].
Assigning a format converter output
You can assign format converter outputs 1 to 16 to format
converter output connectors 1 to 16 or spare connectors 1
to 4.
You can also assign frame memory outputs 1 to 20.
1)
1)
1)
1)
1)
2)
Notes
• Frame memory outputs 1 to 20 cannot be assigned when
the switcher signal format is 3840×2160P,
3840×2160PsF, or 1080P.
• On the XVS-7000, format converter outputs 9 to 16 are
assigned to format converter output connectors 9 to 16.
It is not possible to change settings.
• On the XVS-8000, format converter output connectors
and spare connectors connected to dedicated inputs
cannot be used (see page 435).
• The following functions are not supported on outputs
assigned to format converter output connectors and
spare connectors.
Video clips, vertical blanking, through mode, safe titles,
4:3 crop, AUX bus color corrector, AUX mix transitions
1
In the Engineering Setup >Switcher >Output menu
(7333), press [FC Output Assign].
The FC Output Assign menu (7333.18) appears.
The status area shows a list of output connector
numbers and source names of assigned signals on the
left. The right side of the status area shows a list of
assignable signals.
2
Select the output connector number and signal to
assign.
For signals not assigned, select "Undefined" in the
signal list.
3
Press [Set].

Adjusting Video Clips

1
In the Engineering Setup >Switcher >Output menu
(7333), press [Video Clip].
The Video Clip menu (7333.2) appears.
2
Select the target output to set.
3
Set the following parameters.
No. Parameter Adjustment
2 White Clip
3 Dark Clip
4 Chroma
Clip
To return the parameters to their default settings
Press [Default].
445
Luminance signal white clip value
Luminance signal dark clip value
Chrominance signal clip value