Setting The Internal Format Converters; Setting Internal Format Converter Outputs - Sony XVS-9000 User Manual

Assigning an Ext Out signal to an M/E
dedicated output
You can set an Ext Out signal for each group of four M/E
dedicated outputs (connectors 1 to 4, 5 to 8, 9 to 12, 13 to
16).
You can select from Ext Out1 and Ext Out2 on each
switcher bank, configured using the M/E Ext Output
Assign menu (7333.11), as the output to assign to an M/E
dedicated output.
1
In the Engineering Setup >Switcher >Output menu
(7333), press [M/E Dedicated Out Assign].
The M/E Dedicated Output Assign menu (7333.8)
appears.
The status area shows the M/E dedicated output list on
the left and the switcher bank Ext Out list on the right.
2
In the list on the left, select the target M/E dedicated
output to set.
3
In the list on the right, select an Ext Out signal.
4
Press [Set].
Setting the Internal Format
Converters
Up to 16 channels of internal format converter are
supported by installing an XKS-8460 Format Converter
Board.
Note
On the XVS-9000, internal format converters are not
available.
Setting the format converter configuration
You can set FC channels (FC1 to FC16) in 4-channel
groups (FC1 to FC4, FC5 to FC8, FC9 to FC12, FC13 to
FC16) for input use (input signal conversion) or output use
(output signal conversion).
Notes
• On the XVS-7000, FC9 to FC16 are reserved for output
use only.
• When the switcher signal format is 1080i or 720P, the
FC1 to FC4 setting and FC5 to FC8 setting are linked,
likewise the FC9 to FC12 setting and FC13 to FC16
setting.
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Internal FC].
The Internal FC menu (7333.15) appears.
2
Press [FC Config].
The FC Config menu (7333.16) appears.
3
In the status area, select the target FC channel to set.
4
In the <FC Config> group, select one of the following.
Input: Set the format converter for input use.
Output: Set the format converter for output use.
To clear the setting
Press [Clear].
5
Press [Execute].
Enabling/disabling the 720P converter
When the switcher signal format is 1080P, you can enable/
disable the 720P converter function. The following
conversion formats can be selected depending on the 720P
converter setting.
720P Input signal format
converter
Disabled • 1080P (Level A)
• 1080P (Level B)
• 1080i
Enabled • 1080P (Level A)
• 720P
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Internal FC].
The Internal FC menu (7333.15) appears.
2
Press [FC Config].
The FC Config menu (7333.16) appears.
3
Press [720P I/O Converter] to enable/disable the 720P
converter.
To enable, press [720P I/O Converter], turning it on.
To disable, press [720P I/O Converter], turning it off.
To clear the setting
Press [Clear].
4
Press [Execute].
5
Check the message, then press [Yes].
Setting Internal Format Converter
Outputs
You can set internal format converter outputs if the XKS-
8460 Format Converter Board is installed.
448
Output signal
format
• 1080P (Level A)
• 1080P (Level A)
• 720P