Sony XVS-9000 User Manual page 34

a Mode selection buttons
These buttons select the operation mode of the Flexi Pad
control block. Press a mode selection button to change the
memory recall section to the display for the selected
operation mode.
You can change the assignment of mode selection buttons
in the Setup menu.
For details, see "Setting Flexi Pad Control Block Button
Assignments" (page 403).
Button name Description
KEY Switches to key operation mode.
In key operation mode, you can
carry out the following operations.
• Saving and recalling key
snapshots
• Selecting independent key
transition type
• Displays/selects the key source
signal in the cross-point control
block
WIPE (wipe snapshot) Switches to wipe snapshot
operation mode.
In wipe snapshot operation mode,
you can save and recall wipe
snapshots, and select the wipe
pattern.
DME WIPE (DME wipe Switches to DME wipe snapshot
snapshot) operation mode.
In DME wipe snapshot operation
mode, you can save and recall
DME wipe snapshots, and select
the DME wipe pattern.
SNAPSHOT Switches to snapshot operation
mode.
In snapshot operation mode, you
can save and recall snapshots, and
add attributes.
MASTR EFF (master Switches to effect operation mode.
effect) In effect operation mode, you can
recall and execute the master
timeline.
SHOTBOX Switches to shotbox operation
mode.
In shotbox operation mode, you can
recall and execute shotboxes.
MCRO (macro) Switches to macro operation mode.
In macro operation mode, press
and hold the [MCRO] button and
press a button (for the target
register) in the memory recall
section to enter edit mode.
In macro operation mode, you can
save, recall, and edit macros.
TRANS RATE Switches to transition rate
(transition rate) operation mode.
In transition rate operation mode,
you can enter the transition rate.
b Memory recall section
This section displays the functions assigned to the buttons
for the selected operation mode.
The top right button is used to display the selected pattern
number, register number, macro event number, transition
rate input value, and other status display (excluding in key
operation mode).
When a macro is recalled in macro operation mode, the
bottom center button displays the executed event number
and the total number of events.
Numeric keypad mode
Pressing the [BANK SEL] button, [PTN NO.] button, or
[PAUSE] switches the memory recall section to numeric
keypad mode, where you can enter bank numbers, wipe
pattern numbers, and pause event times.
The currently set numeric value or the value entered using
in numeric keypad mode is displayed on the top right
button.
c UNDO button/DEL (delete) button
After recalling a register, press the [UNDO] button to
return to the state before the register was recalled.
Or press and hold the [DEL] button and press a register
button in the memory recall section to delete the data
registered in the button.
You can change the assignment of buttons in the Setup
menu.
For details, see "Setting Flexi Pad Control Block Button
Assignments" (page 403).
Note
The [UNDO] button and [DEL] button cannot be used in
effect operation mode or shotbox operation mode. The
[UNDO] button cannot be used in macro operation mode.
d Bank selection buttons
These select the target bank to control, and switches the
memory recall section to the register display for the
selected bank.
You can change the assignment of bank selection buttons
in the Setup menu.
For details, see "Key Snapshot Operations (Flexi Pad
Control Block)" (page 136).
Button name
BANK0 to BANK25
34
Description
(Assignment of [BANK3] to
[BANK25] is required.)
Switches the memory recall section
to the register display for the
selected bank.