Sony XVS-9000 User Manual page 417

Command name
DCU GPI1 Test Fire
|
DCU GPI50 Test Fire
Macro Attachment Enbl
Pre Macro
Post Macro
Macro Take
Macro Cancel
Macro Auto Ins
Macro AT with Rate
Macro AT with A/B Bus
Macro TL with Region
DME Override
DME Graphic
FTB
a) The safe title enable/disable commands display the name of the signal
assigned to the output.
Setting names to display in memory recall
buttons
You can set the display of names on buttons when menu
shortcuts or utility commands are assigned to the memory
recall buttons.
Function
Output test trigger from port assigned
to DCU GPI1
|
Output test trigger from port assigned
to DCU GPI50
Macro attachment enable/disable
Sets macro attachment in pre macro
mode.
Sets macro attachment in post macro
mode.
Resume macro execution
Stop macro execution
Macro auto insert mode enable/disable Enabled
Mode enable/disable for storing
transition rate when registering an
auto transition macro event on the
transition control block or transition
control block (simple type)
Mode enable/disable for storing A/B
bus cross-points when registering an
auto transition macro event on the
transition control block or transition
control block (simple type)
Mode enable disable for saving target
regions when registering a timeline
macro event
DME override enable/disable
DME graphics enable/disable
(applies to graphics for channel
selected in device control block)
Fade-to-black execution
Note
When a macro register is assigned, the names specified in
the Macro menu are displayed on the memory recall
buttons. When a shotbox register is assigned, the names
specified in the Shotbox menu are displayed on the
memory recall buttons.
1
2
417
Button state
Lit orange
Output (lit light purple
only at the instant the
button is pressed)
Enabled
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
Pause during
execution (lit purple)
Stop execution (lit
light purple only at the
instant the button is
pressed)
Enabled
Enabled
Enabled
Enabled
Enabled
• Executing (lit light
purple)
• Lit red when
execution
completed (image
in black state)
In the Engineering Setup >Panel >Prefs/Utility
>Utility Module Assign menu (7324.1), select the
target button to set.
Press [Name].
Lit dark blue
Output assigned (lit
purple)
Disabled
Function assigned
Function assigned
• Executing (lit light
purple)
• Function assigned
(gray characters on
black background)
Function assigned (lit
purple)
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Function assigned (lit
purple)