Setting Flexi Pad Control Block Button Display And Operation; Setting The Button And Fader Lever Operation Mode - Sony XVS-9000 User Manual

The source name is updated each time the description
name is updated on the router. This allows you to always
use the same name between the router and the switcher.
The S-Bus description name is reflected in the source
name setting in the Setup menu, hence the name set on the
router is also displayed when [Sw'er Local] is selected in
the <Source/Dest Name> group.
Note
For NS-Bus, this function is ignored.
Setting Flexi Pad Control Block
Button Display and Operation
In the Engineering Setup >Panel >Operation menu (7326),
press [Flexi Pad Mode] to open the Flexi Pad Mode menu
(7326.3).
Configure each function, as required.
Linking the transition type selection with the
Flexi Pad control block operation mode
Press [Wipe/DME Auto Deleg], turning it on.
This switches the operation mode of the Flexi Pad control
block in sync with the selection of the [WIPE] button or
[DME WIPE] button on the transition control block.
Setting the memory recall button display in wipe
snapshot operation mode and DME wipe
snapshot operation mode
In the <Wipe/DME Display> group, select one of the
following.
Pattern: Pattern image display
Register Name: Register name display
Setting the memory recall button display in
snapshot operation mode and effect operation
mode
In the <Snapshot/Effect Display> group, select one of the
following.
Register No: Register number display
Register Name: Register name display
Assigning a register to bottom left button of bank
0
In the <Bank 0 Register Assign> group, select one of the
following.
Register Assign: Assign a register. Select the register
number using the following parameter.
No. Parameter Adjustment
1 Register Register number
No.
a) 1 to 99 configurable only
Register No Assign: Disable register assignment.
a)
422
Note
The bottom left button of bank 0 cannot be selected in the
Misc >Snapshot menu on each switcher bank.
Setting the Button and Fader Lever
Operation Mode
In the Engineering Setup >Panel >Operation menu (7326),
press [Custom Button/Fader] to open the Custom Button/
Fader menu (7326.4).
Configure each function, as required.
Setting the double-press operation mode of the
[BKGD] button in the transition control block
In the <Bkgd Trans Btn Double Clk> group, select one of
the following.
Disable: Double-pressing of the [BKGD] button is
disabled.
Enable: When the [BKGD] button is pressed twice in
quick succession, all currently inserted keys are
selected and removed by the next transition.
Setting the operation mode when the [FTB]
button is pressed during fade-to-black
In the <FTB> group, select one of the following.
Continue: Continue the fade-to-black.
Cancel: Cancel the fade-to-black, and return to the
previous state.
Setting the operation mode when the [AUTO
TRANS] button or [TAKE] button is pressed
during an auto transition
In the <Auto Trans/Take> group, select one of the
following.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition, and return to the
previous state.
Setting the transition indicator display in non-
sync state
In the <Non Sync Fader Indicator> group, select one of the
following.
Normal: The transition indicator is lit when in non-sync
state.
Blink: The transition indicator is blinking when in non-
sync state.
Setting the button display state when executing
an auto transition using the [AUTO TRANS]
button
In the <Auto Trans/Take Key On Stats> group, select one
of the following.
Disable: Lit amber during transition execution, and goes
off at the end of the transition.
Enable: Lit green during transition execution, and at the
end of the transition it is lit red if on-air or lit amber if
not on-air.