Setting An Input Format Converter - Sony XVS-9000 User Manual

When [Adaptive Y] or [Adaptive Y/C] is selected, set the
following parameter.
No. Parameter Adjustment
2 Motion Motion detection sensitivity
Select
a) 1: Mode with highest proportion converted from frames (still picture
priority mode)
2: Mode with higher proportion converted from frames
3: Mode with higher proportion converted from fields
4: Mode with highest proportion converted from fields (motion priority
mode)
To set the up-converter conversion mode
In the <Conversion> group, select the conversion mode.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive: Detects motion in the signal, and automatically
switches mode between conversion using frame units
and field units.
When [Adaptive] is selected, set the following parameter.
No. Parameter Adjustment
2 Motion Motion detection sensitivity
Select
a) 1: Mode with highest proportion converted from frames (still picture
priority mode)
2: Mode with higher proportion converted from frames
3: Mode with higher proportion converted from fields
4: Mode with highest proportion converted from fields (motion priority
mode)
To return the conversion method settings to the
defaults
Press [Default]. The settings for the selected FC channels
are reset to the defaults.
Setting the frame delay
You can set the input signal delay level for each FC
channel.
1
In the Engineering Setup >Switcher >Input >Internal
FC menu (7332.5), select the target FC channel to set.
2
Set the following parameter.
No. Parameter Adjustment
3 Frame Delay level
Delay
a) The following delay levels can be configured, depending on the
switcher signal format.
3840×2160P, 1080P: 1 to 15 frames
3840×2160PsF, 1080PsF, 1080i: 1 to 8 frames
720P: 1 to 15 frames (set value of 1 to 8 frames when the conversion
format is 1080i/576i/480i, with an actual delay that is double the set
value)
a)
a)
a)
439
Setting the frame synchronizer
You can enable/disable the frame synchronizer for each
FC channel. When the frame synchronizer is enabled,
unsynchronized input signals are synchronized.
Note
The frame synchronizer cannot be enabled in the following
cases.
• When the switcher signal format is 3840×2160P or
3840×2160PsF
• When the switcher signal format is 1080P and the 720P
converter is enabled
1
In the Engineering Setup >Switcher >Input >Internal
FC menu (7332.5), select the target FC channel to set.
2
Press [Frame Sync] to enable/disable the frame
synchronizer.
To enable, press [Frame Sync], turning it on. To
disable, press [Frame Sync], turning it off.

Setting an Input Format Converter

You can set an input format converter, frame delay, and
frame synchronizer for primary inputs of an XKS-S8111
SDI Input and FC Connector Board or XKS-S8112/
XKS-S9112 12G-SDI Input Board.
Enabling/disabling an input format
converter
When an XKS-S8111 is installed in the XVS-8000/7000/
6000, you can enable/disable the format converter function
for each input connector board.
Notes
• For the XKS-S8112/XKS-S9112, setup is not required.
• When the switcher signal format is 3840×2160PsF or
1080PsF, the format converter function is not available.
• When the switcher signal format is 1080P, the format
converter function is enabled. The signal formats that
can be converted vary depending on the 720P converter
setting.
1
In the Engineering Setup >Switcher >Input menu
(7332), press [Input FC/CCR].
The Input FC/CCR menu (7332.1) appears.
2
Press [FC Format].
The FC Format menu (7332.7) appears.
3
Select the target input connector board to set.