Snapshot Operations (Numeric Keypad Control Block); Saving And Recalling Snapshots; Snapshot Operations; Block) - Sony XVS-9000 User Manual

Attributes Region
M/E-1,
M/E-2,
M/E-3,
M/E-4,
M/E-5,
PGM/PST
Cross-point hold
Key disable
Effect dissolve
Auto transition
Clip auto play
Attribute display
You can check the attributes added to a snapshot in the
Snapshot menu (see page 332)
Temporary attributes
When recalling a snapshot, you can temporarily enable
attributes distinct from the attributes set for each register.
These are called "temporary attributes."
You set temporary attributes when recalling a snapshot.
Bus override
If you recall a snapshot while holding down an A or B bus
button, the selection of the signal on the A or B bus does
not change when the snapshot is recalled. This function is
called "bus override."
This function is effective when cross-point hold is not set,
and you want to temporarily maintain the cross-point
setting. When cross-point hold is set, bus override
operation is not necessary.
Yes: Available, No: Not available
User1 to DME ch1
8 to ch4
Yes Yes Yes
Yes No No
Yes Yes Yes
Yes No No
No Yes No
.

Snapshot Operations

(Numeric Keypad Control

Block)

Saving and Recalling Snapshots

SNAPSHOT button
STORE button
RCALL button
STORE STATS button
Region selection buttons
Numeric keypad control block
Saving a snapshot
1
Set the state you want to save as a snapshot.
2
In the numeric keypad control block, press the
[SNAPSHOT] button.
The control block switches to snapshot operation
mode, and the [SNAPSHOT] button and [RCALL]
button light amber.
3
Use the region selection buttons to select the target
region of the operation.
You can select more than one button.
The following region selection buttons can be operated
for snapshots.
326
AUTO TRANS button
EFF DISS button
Display
UNDO button
Numeric keypad buttons