Sony XVS-9000 User Manual page 440

No. Parameter Adjustment
1 Group No Input group number
a) Inputs on an input connector board form a group.
4
In the <Format Converter> group, select one of the
following.
Enable: Enable the format converter function.
Disable: Disable the format converter function.
To clear the setting
Press [Clear].
5
Press [Execute].
6
Check the message, then press [Yes].
Note
It may take a few minutes until the configuration is
completed.
Enabling/disabling the 720P converter
On an XKS-S8111, when the switcher signal format is
1080P, you can enable/disable the 720P converter. The
following conversion formats can be selected depending
on the 720P converter setting.
• When the 720P converter is disabled: 1080P (Level A),
1080P (Level B), 1080i
• When the 720P converter is enabled: 1080P (Level A),
720P
Note
For the XKS-S8112/XKS-S9112, setup is not required.
1
In the Engineering Setup >Switcher >Input >Input FC/
CCR menu (7332.1), press [FC Format].
The FC Format menu (7332.7) appears.
2
Select the target input connector board to set.
No. Parameter
1 Group No
a) Inputs on an input connector board form a group.
3
Press [720P Converter] to enable/disable the 720P
converter.
To enable, press [720P Converter], turning it on. To
disable, press [720P Converter], turning it off.
To clear the setting
Press [Clear].
a)
Adjustment
a)
Input group number
4
Press [Execute].
5
Check the message, then press [Yes].
Note
It may take a few minutes until the configuration is
completed.
Setting the conversion format
You can set the signal format of inputs to convert by the
format converter.
The conversion format is set in the following groupings,
depending on the switcher signal format.
• XKS-S8111
- 3840×2160P, 1080P: Groups of 4 inputs
- 1080i, 720P: Groups of 8 inputs
• XKS-S8112
- 3840×2160P, 1080P, 1080i, 720P: Groups of 4 inputs
• XKS-S9112
- 3840×2160P 2SI, and the conversion format is
3840×2160P 2SI 12G, 1080P, 1080i: Groups of 2
1)
inputs
- 3840×2160P 2SI, and the conversion format is
3840×2160P 2SI 3G, 3840×2160P SQD: Groups of 4
inputs
- 1080P, 1080i: Groups of 4 inputs
1) Groups of 4 inputs when the conversion format is initially set to
3840×2160P 2SI 3G or 3840×2160P SQD and then the conversion format
is changed
Notes
• When the switcher signal format is 3840×2160PsF or
1080PsF, input signal format conversion is not available.
• Only 3840×2160P 2SI, 1080P, and 1080i switcher signal
formats are supported on the XVS-9000.
• The signal formats that can be converted vary depending
on the input format converter board and the 720P
converter setting.
For details about the 720P converter, see "Enabling/
disabling the 720P converter" (page 440).
Supported formats
The supported conversion formats are given below.
Note
Field frequency and frame frequency conversion is not
supported.
440