Settings Relating To Video Switching; Enabling/Disabling The Fade-To-Black Function; Setting A Preset Color Mix; Setting Fader Lever Operations - Sony XVS-9000 User Manual

Settings Relating to Video
Switching
Enabling/Disabling the Fade-to-
Black Function
In the <FTB> group of the Engineering Setup >Switcher
>Transition menu (7334), select the program output.
To enable fade to black, press [PGM1] to [PGM4], turning
them on.
Note
The PGM2 to PGM4 settings are enabled in multi program
mode or DSK mode only.

Setting a Preset Color Mix

1
In the Engineering Setup >Switcher >Transition menu
(7334), press [Preset Color Mix].
The Preset Color Mix menu (7334.1) appears.
2
In the <Show Key Enable> group, select the target
output to set.
3
In the <Stroke Mode> group, select a stroke mode.
Normal: Carry out a preset color mix with two
transition operations.
Single: Carry out a preset color mix with a single
transition operation.
Note
In bus fixed mode, the setting is fixed to [Single].
4
In the <Non Drop Key> group, select the key state for
a transition including a key.
To execute a transition with the key state maintained,
press [Key1] to [Key8], turning them on.
5
To return to the previous transition type setting each
time a transition ends, press [One Time Enable],
turning it on.

Setting Fader Lever Operations

This sets the relationship between the fader lever position
and the progress state of the transition when executing a
transition.
1
In the Engineering Setup >Switcher >Transition menu
(7334), press [Transition Curve].
The Transition Curve menu (7334.2) appears.
2
In the <Fader Curve> group, select the fader lever
operation mode.
Normal: The transition progress is linear, according to
the fader lever position (factory default mode).
Adv Tally Mode: When the fader lever is moved from
the end of its travel, the tally is output slightly
before the transition starts.
Setting the DME Wipe Edge
Softness Function
You can display the input image filling the frame when
executing a DME wipe by disabling the edge softness
function.
Notes
• This setting is available only when the signal format is
1080i.
• When side flags are enabled, this setting is available only
when [16:9] is selected in the <Aspect> group in the
Engineering Setup >Switcher >Config >Side Flags
menu (7331.7).
In the Engineering Setup >Switcher >Transition menu
(7334), press [Full Size Edge Soft] to enable or disable.
Disabling will disable the edge softness function in any of
the following cases.
• When [Crop] is disabled in the <Crop Mode> group in
the DME Wipe >Modify menu of each switcher bank
• When [Crop] is enabled in the <Crop Mode> group in
the DME Wipe >Modify menu of each switcher bank
and the [Top] and [Right] parameters are set to "100.00"
and the [Left] and [Bottom] parameters are set to
"–100.00"
• When the DME wipe direction is reverse and before
execution of the transition

Selecting the Bank to Configure

In the Engineering Setup >Switcher >Transition menu
(7334), select the target bank to set and then configure the
bank.
No. Parameter Adjustment
1 Bank
455
Switcher target bank selection