Copying Cross-Point Pad Settings; Setting The Display Mode Of The Cross-Point Control Block/Aux Bus Control Block - Sony XVS-9000 User Manual

To rename a page
The operation is the same as for the Xpt Pad Btn Assign
menu (7326.14) (see page 425).

Copying Cross-Point Pad Settings

You can copy cross-point pad settings on cross-point
control blocks/AUX bus control blocks.
Copying by cross-point pad
You can copy the following cross-point pad settings
between cross-point control blocks/AUX bus control
blocks.
• Assignments of all page buttons
• HOME page settings
• Page recall function settings
• Display mode settings (see page 427)
• Utility bus mode settings (cross-point control block
only) (see page 428)
Copying by page
You can copy the following settings between pages in the
cross-point pad.
• Assignments of target page buttons
• Page recall function settings of target page
Note
You cannot copy cross-point pad settings between the
cross-point control block and AUX bus control block.
Copying settings by cross-point pad
1
In the Engineering Setup >Panel >Operation >Xpt
Module Operation menu (7326.12), press [Xpt Pad
Copy].
The Xpt Pad Copy menu (7326.18) appears.
2
In the list on the left, select the copy source cross-point
control block/AUX bus control block.
3
In the list on the right, select the copy destination
cross-point control block/AUX bus control block.
4
Press [Copy].
To copy using buttons
You can copy by cross-point pad using button operation.
Press and hold the [XPTPAD COPY] button on the source
cross-point pad, then press the [XPTPAD COPY] button
on the destination cross-point pad to copy the settings.
Copying settings by page
1
In the Engineering Setup >Panel >Operation >Xpt
Module Operation menu (7326.12), press [Xpt Pad
Page Copy].
The Xpt Pad Page Copy menu (7326.19) appears.
2
In the list on the left, select the copy source cross-point
pad page.
3
In the list on the right, select the copy destination
cross-point pad page.
4
Press [Copy].
To switch to page name display
Press [Page Name Display], turning it on. The name is
displayed instead of the page number.
Setting the Display Mode of the
Cross-Point Control Block/AUX Bus
Control Block
This sets the information that appears on the display of the
cross-point control block/AUX bus control block.
The display content and format can be selected for each of
six types of display mode.
1
In the Engineering Setup >Panel >Operation >Xpt
Module Operation menu (7326.12), press [Display
Mode Setting].
The Display Mode Setting menu (7326.15) appears.
The left side of the status area shows six display
modes, and the right side shows a list of items to
display.
2
In the <Bank Select> group, select the target bank to
set.
3
Select the target display mode to set.
4
To divide the display into upper/lower to display two
pieces of information, press [Split], turning it on.
5
In the list on the right, select the item to display.
6
Perform the following operations.
• When [Split] is not lit, press [Set] in the <Lower
Area> group.
• When [Split] is lit, press [Set] in the <Upper Area>
group to set the display in the upper area, and in the
<Lower Area> group to set the display in the lower
area.
427