Sony XVS-9000 User Manual page 30

Pattern limit setting buttons
(Assignment in the Setup menu is required.)
These buttons are used to set pattern limits.
• PTN (pattern) LIMIT button
• LIMIT SET button
For details about pattern limits, see "Pattern Limit"
(page 92).
External device operation buttons
(Assignment in the Setup menu is required.)
These buttons are used to control playback, stop, and cue-
up operations on connected devices.
• PLAY button
• STOP button
• CUE button
For details about operation of external devices, see
"Control of VTRs and Disk Recorders" (page 283).
c Transition execution section
This section is used to execute transitions and check the
progress of the transition.
Transition
indicator
Fader lever
Transition rate display
AUTO TRANS button
Name Description
Fader lever • Move this up or down to carry out
the transition.
• Press the [KF] button, turning it
on, to enable the fader lever to be
used as a keyframe fader.
Transition indicator Displays the transition progress
using LEDs.
Transition rate display Displays the configured transition
rate (the time from the beginning of
a transition to its completion).
AUTO TRANS (auto • Executes an auto transition with
transition) button
the set transition rate and
transition type.
• During the transition, the button
is lit amber.
CUT button
Name
CUT button
d Independent key transition execution section
This section executes independent key transitions.
Independent key transition display section
KEY1 ON to KEY4 ON buttons
Name
Independent key
transition display
section
KEY1 ON to KEY8 ON
buttons
AUTO TRANS (auto
transition) buttons
You can change the position of the key 1 to key 8 operation
buttons in the Setup menu. However, the [AUTO TRANS]
button is assigned with the [KEYx ON] (x = 1 to 8) button
of the same key as a set.
For details, see "Setting Transition Control Block Button
Assignments" (page 403).
30
Description
Executes an immediate transition.
KEY5 ON to KEY8 ON buttons
AUTO TRANS buttons
Description
Displays the following information
for key 1 to key 8.
Key material name (key source
name when a key source is
selected on the key bus of the
cross-point control block), DME
channel or resizer being used,
transition rate, and transition type
• Inserts or removes the key
instantaneously.
• If a key is currently inserted, the
corresponding key button is lit
amber.
• Inserts or removes the key
automatically, for key 1 to key8,
with the set transition rate and
transition type.
• During the transition, the button is
lit amber.