Sony XVS-9000 User Manual page 411

The Source Table Assign menu (7323.2) appears.
2
In the <Source Table Select> group, select the target
source table to set.
3
Press [Table Assign].
The Table Assign menu (7323.3) appears.
4
Select the target button number to set and the source to
assign.
To inhibit operation of buttons, press [Inhibit].
5
Press [Source Set].
To set the [SHIFT] button operation
In the <Xpt Shift Mode> group of the Source Table Assign
menu (7323.2), select one of the following.
Hold: The source on the shifted state of the cross-point
button is enabled while pressing the [SHIFT] button.
Lock: Pressing the button toggles between the sources on
the shifted and unshifted state of the cross-point
buttons.
Off: Functions as a cross-point button, namely, button
number 20 on a 20-button system, button number 28
on a 28-button system, and button number 36 on a 36-
button system.
Note
The [SHIFT] button operation mode is enabled only when
second delegation mode is set.
Assigning levels to level selection buttons
1
In the Engineering Setup >Panel >Aux Assign >RTR
Mode Setting menu (7323.1), press [Level Button
Assign].
The Level Button Assign menu (7323.4) appears.
2
In the <Level Button Select> group, select the target
button to set.
3
In the <Level Assign> group, select the level to assign
to the button.
You can select more than one level. You can also
duplicate the selection on another button.
Selecting a destination selection button for
a snapshot
You can set whether snapshots are recalled for each
destination selection button.
1
In the Engineering Setup >Panel >Aux Assign >RTR
Mode Setting menu (7323.1), select the target
destination button number to set.
2
Press [SS Enable] to enable/disable the function.
To enable, press [SS Enable], turning it on. When a
snapshot of the router is recalled, the destination
selection buttons set the destination for the recall.
Note
When a destination selection button is set to Inhibit,
the destination snapshot is not recalled.
411