Reset And Initialization; Settings Relating To Installation And Devices; Displaying Installation Detail Information; Installing Software - Sony XVS-9000 User Manual

Reset and Initialization

You can reset or initialize memory on each device.
• Reset: Reset to power-on state.
• All Clear: Clear the memory, and reset to factory default
state. The Network Config, System Config, Format, and
Start Up settings are set using data stored in non-volatile
memory, and the system automatically starts up. It is not
necessary to reset the Date/Time settings.
For details, see "Saving and Recalling Setup Data"
(page 392).
Resetting devices and initializing memory
Note
When the switcher is reset, the DME is also reset at the
same time.
1
In the Engineering Setup >System >Initialize menu
(7315), select the target device to operate.
2
In the <Initialize> group, select one of the following.
Reset: Reset the device.
All Clear: Initialize memory.
3
Press [Execute].
4
Check the message, then press [Yes].
Settings Relating to
Installation and Devices
You can install software and firmware for devices
connected to the LAN.
Displaying Installation Detail
Information
In the Engineering Setup >System >Install/Unit Config
menu (7316), press [Detail Information].
The Detail Information menu (7316.1) appears, displaying
detailed information about the software and firmware
installed in the currently selected device.

Installing Software

1
Connect a removable drive containing software to
install to the DEVICE connector of the menu panel.
2
In the Engineering Setup >System >Install/Unit
Config menu (7316), press [Install].
The Install menu (7316.10) appears.
The following content is displayed in the status area.
Upper list: For each connected device, this shows the
device name, current software version (Current),
and the latest version that can be installed (Install,
Title).
OK: Installation already completed.
On: Cued for installation, but not completed.
Error: An error occurred during installation.
Lower list: For the device selected in the upper list,
this shows an automatically determined list of
software that can be installed on the particular
device. Also, software that is a candidate for
installation in the upper list is marked in the lower
list with a
3
To change the candidates for installation, select the
target device in the upper list, and select the software
to install in the lower list.
If you are satisfied with the installation candidates in
the upper list, skip to step 5.
To display all related software
Press [Display All Software], turning it on.
All related software for the selected device appears,
not just the automatically determined software.
393
mark.