Dme Wipe Modify Clear; Basic Independent Key Transition Dme Wipe Setting Operations; Selecting An Independent Key Transition Wipe Pattern; Setting Independent Key Transition Dme Wipe Modifiers - Sony XVS-9000 User Manual

completion from 70% ([Last 30%]), 95% ([Last 5%]), and
100% ([Off]).
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
3
In the <Release Transition> group, select the timing of
transition completion.
Last 30%: The transition completes at the end of 70%
of the transition execution time. The transition has
a dead zone from 70% to 95% of the transition
time.
Last 5%: The transition completes at the end of 95%
of the transition execution time. When the
transition completes, the cropping is removed
during the last 5% (enlarges).
Off: The transition completes at the end of the
transition execution time. During the last 5% of
the transition, the transition and cropping removal
proceed together.
Dead zone

DME Wipe Modify Clear

Press [Default Recall] at the lower left of the menu display,
turning it on, then press the VF6 button ([DME Wipe]) to
return the DME wipe settings to their initial status.
For details about initial status, see "Power-On (Startup)
State Selection" (page 391).
Transition
Crop
t: Transition execution time
y: Change in transition and
cropping amount
162
Basic Independent Key
Transition DME Wipe
Setting Operations
You carry out independent key transition DME wipe
setting operations using the DME Wipe Adjust menu for
each keyer.
For details about independent key transitions, see
"Independent Key Transitions" (page 98).
This section describes operations of key 1 on the M/E-1
bank (M/E-1 >Key1 >Transition/Video Process >DME
Wipe Adjust menu) as an example.
Selecting an Independent Key
Transition Wipe Pattern
1
In the M/E-1 >Key1 >Transition/Video Process menu
(1117), press [DME Wipe Adjust].
The DME Wipe Adjust menu (1117.3) appears.
2
In the <Pattern Select> group, press [1ch] for 1-
channel mode or [2ch] for 2-channel mode.
The 1ch Pattern Select menu (1117.4) or 2ch Pattern
Select menu (1117.5) appears.
3
Press the button for the desired DME wipe pattern
group to select it.
The patterns from the selected pattern group appear on
the screen.
If executing a DME wipe using a resizer
Select [Resizer Slide], [Resizer Squeeze], or [Resizer
Frame I/O] in the DME wipe pattern group.
4
Press the desired pattern to select it.
Setting Independent Key Transition
DME Wipe Modifiers
You can add modifiers, such as pattern position and size,
to an independent key transition DME wipe.
For an overview of modifiers and supported pattern
numbers, see "DME Wipe Pattern Variation and
Modifiers" (page 156).