Sony XVS-9000 User Manual page 161

3
Press [Size], turning it on.
4
Set the following parameter.
No. Parameter Adjustment
1 Size Effect size
a) 100% indicates the unchanged size state.
Display indications when multiple channels are
selected at the same time
The parameter setting value display shows the settings
of the lowest-numbered channel. When you adjust the
settings, this adjusts the settings on the other channels
by the same amount.
Adjusting the DME wipe pattern cropping
(Crop)
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Ch Select> group, select the target channels.
For a pattern in 1-channel mode: Select [1st Ch].
For a pattern in 2-channel mode or 3-channel
mode: Select the corresponding channels. You
can select more than one channel at the same time.
For some patterns, the <Ch Select> group
selection is fixed and requires no setting.
3
In the <Crop Mode> group, press [Crop], turning it on.
4
Set the following parameters.
Parameter group [1/2]
No. Parameter Adjustment
1 H Crop the left and right of the image
2 V Crop the top and bottom of the
image
3 All Crop the top, bottom, left, and right
of the image
Parameter group [2/2]
No. Parameter Adjustment
1 Top Crop the top of the image
2 Left Crop the left of the image
3 Right Crop the right of the image
4 Bottom Crop the bottom of the image
Display indications when multiple channels are
selected at the same time
The parameter setting value display shows the settings
of the lowest-numbered channel. When you adjust the
settings, this adjusts the settings on the other channels
by the same amount.
a)
161
To crop to 4:3 aspect ratio in 16:9 mode
In the <Crop Mode> group, press [4:3 Crop].
To set the action when a DME wipe crop
transition is executed
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Ch Select> group, select the target channels.
For a pattern in 1-channel mode: Select [1st Ch].
For a pattern in 2-channel mode or 3-channel
mode: Select the corresponding channels. You
can select more than one channel at the same time.
3
In the <Crop Mode> group, press [Crop], turning it on.
4
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
5
In the <Crop Transition> group, select the execution
mode for the DME wipe crop transition.
Cut: Cut mode. The cropping does not change during
the transition, but at the end point of the transition
the cropping is removed (enlarges).
Last 5%: The cropping is maintained for the first 95%
of the transition, and is progressively removed
during the last 5% of the transition (enlarges).
Linear: The cropping is removed linearly from the
start of the transition through the whole course of
the transition (enlarges).
To set the timing of transition completion
When the execution mode for a DME wipe crop transition
is set to [Last 5%], you can select the timing of transition
Transition
Crop
t: Transition execution
time
y: Change in transition
and cropping amount