Sony XVS-9000 User Manual page 364

For details, see "Setting the Macro Execution Mode"
(page 423).
• Individual events stored in a macro are executed
according to the settings in the Setup menu. If you
change the settings in the Setup menu, a saved macro
may not have the expected effect.
• During macro execution, if you switch the control panel
to macro editing mode, the macro currently being
executed stops.
• During macro editing, pressing a button for which a
macro attachment is set does not execute the macro.
To disable macro attachment settings
Depending on the location of the button you want to
disable, press the [MACRO ATTACH ENABLE] button
(or button assigned with the "Macro Attachment Enbl"
command), turning it off.
If using the [MACRO ATTACH ENABLE] button on the
cross-point pad or a memory recall button in the utility/
shotbox control block, press it, turning it on dark blue.
In this state, pressing a button for which a macro
attachment is set does not execute the macro.
Executing a macro assigned to a fader
lever
1
In the cross-point control block for the fader lever on
which you want to execute the macro, press the
[MACRO ATTACH ENABLE] button in the cross-
point pad, turning it on orange.
2
Move the fader lever from the start position to the end
position.
When the fader lever passes the position at which the
macro attachment is set, the macro register is recalled,
and the macro is executed.
Notes
• Unless you move the fader lever to the end position
(completing the travel), it is not possible to execute the
macro again.
• When the preset color mix stroke mode is [Normal], the
first lever operation executes the macro, but the second
lever operation does not.
For details about setting the stroke mode, see "Setting a
Preset Color Mix" (page 455).
• If a button is pressed twice during macro execution or
when the macro is stopped, or if another macro is
recalled, the following operation depends on a setting in
the Setup menu.
For details, see "Setting the Macro Execution Mode"
(page 423).
• Individual events stored in a macro are executed
according to the settings in the Setup menu. If you
change the settings in the Setup menu, a saved macro
may not have the expected effect.
• During macro execution, if you switch the control panel
to macro editing mode, the macro currently being
executed stops.
• During macro editing, even if you operate a fader lever
with a macro attachment set, the macro is not executed.
To disable macro attachment settings
In the cross-point control block for the fader lever you
want to disable the macro, press the [MACRO ATTACH
ENABLE] button in the cross-point pad, turning it on
orange.
In this state, operating a fader lever with a macro
attachment set does not execute the macro.
364